Aurora uses four metrics to show how much sunlight reaches a roof or panel: irradiance, solar access, TOF, and TSRF. This article defines each one and shows where to find it.
In this article:
What it is
Shading metrics tell you how much sunlight a surface receives over a year and how much of it is lost to shade, tilt, and orientation. Use them to compare roof faces and decide where to place panels.
Key terms
- Irradiance — The solar energy that reaches a surface, per square meter. Aurora shows annual irradiance in kWh/m²/yr.
- Solar access — The share of sunlight that still reaches a point after shade from trees, buildings, and other objects. It's the solar energy the point receives with shade, divided by what it would receive with no shade. Aurora also calls this solar access percentage (SAP).
- TOF (tilt and orientation factor) — The sunlight a surface receives at its actual tilt and orientation, compared with what it would receive at the optimal tilt and orientation for the site. Aurora works out the optimum from the site's weather data.
- TSRF (total solar resource fraction) — Shade, tilt, and orientation combined into one number. TSRF equals solar access multiplied by TOF.
How it works in Aurora
Aurora calculates these metrics from your site model — the roofs, trees, and obstructions you draw — plus LIDAR data when LIDAR shading is on. You can see them in four places.
In Design Mode
- Irradiance map — Click Irradiance in the toolbar, or press I. The Annual irradiance panel lists Irradiance, Solar Access, TOF, and TSRF. Hover the roof or panels to see the values at a point. For details, see Running an irradiance map in Design Mode.
- Roof face information — Select a roof face. Under Annual average across roof face, you'll see Irradiance, Solar access, TOF, and TSRF for the whole face, with or without panels on it.
In Sales Mode
The System's annual irradiance panel shows Solar access, TSRF, and Irradiance for the system. It appears only when the design has panels, and it doesn't show TOF. Click the info icon (ⓘ) on the panel to see definitions.
In the shade report
The Summary table lists Annual TOF, Annual solar access, and Annual TSRF for each array. For details, see Shade report: sections and values
In AutoDesigner
Admins can set minimum solar access and TSRF values that AutoDesigner uses to decide where to place panels. For details, see Design settings – Account configuration.
Key considerations
- Shaded points still get some light. Where shade blocks the direct sun, Aurora still counts diffuse light from the sky and light reflected from the ground, so a shaded point keeps part of its solar access. For details, see Diffuse irradiance: overview.
- TOF stays the same across a roof face. Because TOF depends only on tilt and orientation, it's the same at every point on a face. Solar access and TSRF vary from point to point.
- Solar access isn't a production estimate. To see how shade affects production, click Simulate system, then check the Shade loss under System losses. For details, see System Loss Diagram.
- Incentive programs may set minimums. Some programs require a minimum TSRF, and their rules change. Check the program's current requirements before you submit a design.
FAQ
Why does my east- or west-facing roof show 100% solar access?
Solar access measures only shade. If nothing shades the roof, it shows 100% solar access, even on a steep east- or west-facing roof. The roof's orientation lowers its TOF and TSRF instead.
Why doesn't solar access times TOF match the TSRF shown?
Aurora rounds each value it displays, so multiplying the rounded numbers can give a slightly different result. For example, 90% solar access times 96% TOF is 86.4%, but the TSRF can show 87%.
Where do I find the TSRF for a roof face?
In Design Mode, select the roof face. Roof face information shows its TSRF under Annual average across roof face. To see the TSRF at a single point, turn on Irradiance and hover the roof.