Submodule simulation models each cell string inside a module instead of treating the module as one unit. A cell string is a group of cells with its own bypass diode, which can route current around the cell string when it's shaded. Modeling cell strings gives a more detailed estimate for designs where shade covers only part of a module.
In this article:
- How it works in Aurora
- Turning on submodule simulation
- Checking whether a module supports it
- When a panel doesn't support it
- Related articles
How it works in Aurora
To run a submodule simulation, turn on Submodule simulation and use modules that support it. If any panel's module doesn't support it, Aurora runs a module-level simulation instead.
- Bypass diodes. Aurora models bypass diodes for inverters with global MPPT, and in designs with DC optimizers whose Has a global MPPT value is Yes. In a submodule simulation, the log shows one bypass diode per cell string with a 0.7 V forward voltage drop. See Global MPPT and Bypass Diodes.
- Default for new designs. Admins set it with Use sub-module simulation if available in Settings > Performance simulations.
- Results. The simulation log shows "Simulation type: Submodule-level" or "Simulation type: Module-level."
Turning on submodule simulation
These steps start from a design in Design Mode and end with an updated simulation.
- Click Settings (the gear icon) in the toolbar.
- Click the Simulation tab.
- Turn on Submodule simulation in the Aurora section.
- Click Simulate system.
To confirm, click Production in the summary bar, then Advanced > Simulation logs. The log shows "Simulation type: Submodule-level."
Checking whether a module supports it
The component database shows which modules have the cell string data that submodule simulation needs. If you don't see Database, ask your account admin.
- Go to Database > Modules.
- Search for the module, then click it.
- Check Submodule simulation in View component. It shows Supported or Not supported, and Cell quantity shows the number of cells.
When a panel doesn't support it
If any panel's module doesn't support submodule simulation, Aurora runs a module-level simulation and doesn't show a message on screen. The top of the simulation log says: "Submodule simulation requires that all panels have cell string configurations. Proceeding without submodule simulation." To use submodule simulation, switch to a module that shows Supported, then simulate again.