Inverter clipping happens when the panels produce more DC power than an inverter can convert to AC. The inverter's output levels off at its rated AC power, and the extra energy is lost. Because many systems use an array that's larger than its inverter, some clipping is common.
In this article:
How it works in Aurora
- The AC limit. The Aurora engine limits each inverter's output to its Rated power, which you can see in Database > Inverters.
- The setting. The Inverter clipping toggle in the Aurora section of a design's Simulation tab turns clipping on or off. Admins set the default for new designs in Settings > Performance simulations.
- The results. Clipping appears as the Inverter Clipping row in the AC section of the system loss diagram, after DC/AC Conversion. The simulation log shows "Inverter clipping: Enabled" or "Inverter clipping: Disabled."
With Inverter clipping off, the simulation ignores the AC limit. Production goes up, and the Inverter Clipping row shows 0.0%.
To see how much energy clipping removes from a design, open the system loss diagram and find the Inverter Clipping row. See System loss diagram.
Key considerations
- Some clipping is common. Many systems have a DC-to-AC ratio above 1 to lower costs — the median for US systems was 1.34 in 2020 — so the array sometimes produces more than the inverter can convert. See NREL's study Quantifying the impact of inverter clipping on photovoltaic performance and soiling losses.
- There's no clipping warning. Aurora doesn't show a warning for clipping, however large it is, so check the Inverter Clipping row when you review a design.
- Leave clipping on for realistic estimates. With it off, the estimate assumes the inverters can output more than their rated power.
- Reducing clipping. To clip less, lower the design's DC-to-AC ratio, for example by choosing a larger inverter.
FAQ
I'm seeing clipping on my installed system that my design doesn't show. What should I do?
Contact Aurora Support with a link to the design and your system's production data, and the team will review them with you. See How to contact Aurora support.